u/SensualSadistDom

I have a Gen3 AppleTV4K connected to gig fiber. Every other app I have loaded on the Apple device works consistently fine. I have Spectrum configured on it as my cable provider.

Initially installed Spectrum app, launch it, log in, works OK. Worked OK for a few months.

Then one morning load the app, it says "Too many login attempts, go online change your password" or something similar. I have the ONE login I'm trying to make work.

When it first happened, I went online and changed the password and it worked for a week or two until the Spectrum app updated, and then it reported the same error again.

It has so far been unreliably useless. I also have a streaming device that uses Android, and that one has been problem free, leading me to believe that Spectrum's AppleTV app is broken.

There is no way I'm going online every week or two to change my password to keep the app working.

Suggestions?

2004 ES-330 with Nav/ML audio system.

Looking to find 12 volts switched (off when not running or in accessory) in the trunk to power a small 12 volt fan drawing less than 1/2 amp in the trunk area.

I don't seem to have quite the right schematics, and probing around with a voltmeter found nothing like that.

I was hoping the ML audio system would have one that signaled the main amplifier to turn on, but it seems that it runs on a LAN (kinda crazy for a 2004 car) and gets commands from the head end to turn on and off. The amp has the main high current 12 volt feed there all the time.

Thanks.

I'm moving on from a Ubiquity router and Spectrum coax modem I have grown to truly despise. The fiber has been installed and is great.

I have a small Ubiquity router and four 'flying saucer' access points (22 wi-fi clients and a bunch of wired gear like desktops, laptop, printer, streaming devices, consumer entertainment gear) that I moved from the Spectrum modem to the AT&T fiber modem by just moving the CAT6 cable to the router over so I had zero down time. The AT&T modem is in passthrough mode.

Works OK, but there are holes in the coverage (3 story 90 year old lath-n-plaster house that tends to be hard on wifi signal range). I'm far more concerned about coverage than data speed (we don't stream stuff to our two phones but do use wi-fi calling because cell service sucks from all carriers here).

So I bought the AXE5400 mesh system with three nodes and want to get that set up.

Before I reinvent the wheel several times while setting it up, anyone with the same or similar setup care to give some words of advice on setup/configuration?

Much appreciated.

About to change out my old wi-fi system with a new AXE5400 6E mesh system, and want to change the system's previous wi-fi login name, password, and IP range. Is there a way to change that info globally in the app so I don't have to reinstall all 22 of my devices?

Thank you.