u/Superduper4325

Wanted to try and half document my journey and also say thanks to all the amazing people on here for all the help they have given,

I am almost done with printing the leg section of the warlord titan, I have been printing on both a bambu a1 mini and a prusa mk3.9s, I have been printing with a 0.4mm nozzle and 0.08mm layer height, tree supports on. 25-40% infill gyroid

A few things I have learned is that position is everything in these prints, a part that is positioned perfectly will print a million times better than a badly positioned one, also make sure when planning your warlord to add failed print and calibration prints to the amount of filament needed, I am pretty sure I lost a whole spool of filament at the start due to bad settings and print positions.

I do happen to have one question for you guys, should I assemble just the leg parts and paint it or should I wait till it's all done?

I'm happy to answer any questions anyone has, and will probably post another update once I am halfway done.

Thank you everyone for this amazing community and I hope you all have a amazing day!

It spam opened a tab and then crashed edge a bunch of times, I'm on android and cleared all storage, cache and everything from edge just to make sure the extension was gone and uninstalled, is there any way I can verify my phone is fine?

This only happens in areas with supports, any help on how to fix is greatly appreciated, using dried pla on a bambu lab a1 mini with 0.4 nozzle and 0.8mm layer hight

Edit: ignore the bike photo I didn't mean to put that there 😭