u/TheManWhoClicks

Douglas Park, again trash being left behind from some party. I would be ashamed of myself.

Got me loicense too

I’m not a pilot so just asking.

…on my way to the shop. How convenient, what are the odds!

Nobody is safe

Vermisse Berlin sehr!

My first pylote loisense came in the mail and they gave me this. How am I doing guys?

The traffic situation around Erewhon keeps improving.

No wonder playnes are late so often

I had to move from Chitubox to SatelLite because my new Jupiter 2 isn’t supported by Chitibox unfortunately. Beside the fact that SatelLite is some 5x slower than Chitubox with every operation I made so far, for the love of god I can not figure out how to remove those useless micro supports that do nothing but ruin the print. I tried YouTube, I tried to find a comprehensive manual and I tried to figure it out on my own which I am usually good at but I am starting to feel lost. How can I just batch select an area from let’s say a side view (like drawing an area and every support in it gets selected) and just press delete? Just like how any 3d software I have been using for 25 years works? This software doesn’t seem to be very intuitive.

… gets stuck to PET film AND the build plate in a way that the mechanics can’t move the plate up anymore and the build plate snaps down when gears give way, splashing resin everywhere. Exchanged the PET film twice for a new one, all done to the book. Leveled the build plate again as well, no luck. Everything has always worked well until it didn’t anymore. When I adjust the exposure time down a bit, all I get what is seen in the pictures, the print just stays on the PET film. I am at a loss. Even recommended lubricant for the PET film didn’t do the trick. The nature of my prints (outside this test print seen in the images) always do have a large footprint and if Angeles, the raft would have a large one too.
Any ideas what is going on? At this point I am stuck.

Edit: FEP not PET