Was playing as normal, noticed that new mods were out on Modhub, so I saved the game and exited. Had a browse through the new mods and noticed that 3 of the mods I downloaded needed an update so I updated as you do. Re-entered the map and now the FPS has literally taken a nosedive. Tried restarting the game, still nothing.
Clip has not been modified, that clip was recorded immediately after loading in.
(Xbox Series X)
I waited one month after planting this barley to use a medium weeder (last picture is the one I used. On a side note, I don’t really understand when I’m supposed to use a small weeder). I removed the weeds and it was still showing weeds on the map, it said they were (partial), I looked online on what to do and someone said in a YouTube video that you are supposed to spray herbicide over it once you’ve used the weeder to fully remove them and then you get the full 97% yield bonus. Yet after doing that, it’s still showing 87%?
So I don’t really understand what I’ve done wrong. I’ve fertilised the field twice, it’s been rolled, it has been limed & ploughed and did weed removal. Yet, it’s still showing 87% yield bonus. It has not been mulched as that’s only 3%.
I purchased the AL1 & Gisela yesterday and today I decided to have a go of the AL1 tutorial.
On the 3 times I tried it, as I was following the instructions of the tutorial, it came up with the “activate train protection” message numerous times and it still allowed me to operate the train as normal. Because of the message constantly popping up, it wouldn’t let me complete the tutorial.
I then decided to try it in quick play with the DT5 and as pictured I experienced the same issue again and it even popped up as I was slowing down for a station (no red signal was in front) and it still allowed me to accelerate as normal.
I am yet to try Berlin to see if it’s experiencing the same issue but is anyone else who plays this having the same problem?