u/Typical_Helicopter13

When i unlocking bootloader with WPInternals, The program is searching for flashing profile from 0 to 64 and when it goes to 64, OS doesnt boot and it reboots to flash mode. Flashing ffu restores the OS.

I’m struggling with the "Temperature too high" warning on my J3 2017.

Here is the situation:

The phone shows the error and stops charging.

I thought it was a software glitch, so I performed a full firmware flash (clean install). It worked for a few hours, but now the error is back.

It seems like the error is triggered by the USB data connection. Is this definitely a faulty charging port flex cable? I’m hesitant to rip the screen off to replace it if it might be a motherboard issue. Has anyone had this "Temperature too high" error caused by a failing charging port module specifically?

https://preview.redd.it/9oi9mab50iah1.png?width=927&format=png&auto=webp&s=d56d1f0f39b0ee216e8c2806940f48efc4c4cfc7

I use Checkra1n and Cydia. I tried to install file with ideviceinstaller.

i bought pingequa nrf24 + cc1101 module for cardputer ADV and i correctly edited brucepins and module still not working any ideas?