u/Valafar_Actual

Form1 sbr on this dumb lower, with an FTN.5 in the works. Damn, it feels good.

I mean just. Look at it.

Printed on a p1s with Sunlu pa6 with 300blkfde settings.

Upper and buffer adapter should be in tomorrow, and I'll get some classier completed pics then.

Had a form 1 approved this morning, submitted 7/1. So say Hello to the Lil Piglet and its whisper pickle! I'll be testing it out for the first time tomorrow 😎 annoyingly, Sunlu seemed to change the shade of their Olive Green filament some time in the past.

Oh, the can is #38171 from Practical Tactical.

I recently bought a P1P and diy enclosed it, along with adding all of the appropriate fans. It's been great. But last night I gave ABS a shot after fighting with it on an enclosed A1 several months back.

It almost pisses me off just how well it prints on this printer. This print took three hours and is straight as an arrow, zero warping visible. I just wasn't able to get a finished picture this morning.

I've been loving my A1, I've had it for about 18 months now and it's been great. Well, I've been wanting a properly enclosed for a while, and when I found an open box p1p at

Microcenter for $280, I figured that would be close enough. I was already impressed with how well thw A1 printed, and this is a fantastic step up from there.

Well if you're gonna twist my arm.