u/YerBoyAlex

Printer Information

- E3NG with Klipper

- Dual 5015 cooling fans. Tested and appear to be working.

- Orca Slicer with the RH3D E3NG default profile

Filaments Used

- Green Elegoo PLA+

- Inland Purple PLA

- Inland Silk PLA

- 200-205 nozzle temp

- 55-60 bed temp

Fixes I’ve Tried

- Made sure no cables were loose or pinched

- Made sure fans were working properly

- Re-did a PID nozzle tune

- Tried to print an overhang test with already calibrated filament (Green one) and got the same result

- Tried an overhang test slowed by 50%. Same results.

- Did an overhang test where I reduced the temperature by 10 degrees and it didn't change anything.

- Did 2 cold pulls to clear out any possible clogs.

The printer is a new build and it was working greay for about 10 prints. I installed a cable chain because the cables were scraping the top of the enclosure and now I'm suddenly getting horrible overhangs. I checked the cables and everything looks fine and has enough slack. I included a photo of the cable chain in case that raises any red flags. Any suggestions?

Edit: Added some new things that I've tried.

I've been playing Coromon recently and Megalobite has a really cool design. Depresso also really gives me a chuckle whenever I see him. I got to thinking about how many great creature collectors were coming out lately and I'm curious as to everyone's favorites!

I keep getting this error about once a month no matter what I replace.

✅ New Thermistor (I've gone through about 6 thinking this was the issue)

✅ New Heater Cartridge (tried 2 different ones)

✅ New Heater Block

✅ New mainboard (SKR Mini E3 V2)

✅ PID Tune

My printer is enclosed because I print a lot of ABS and Ive considered that the power supply might also be overheating but I haven't done anything for it yet.

Have you had this issue and how did you fix it for good?