he did not think fat enough 😭😭😭😭😭😭

23°41'38.8"N 90°30'12.8"E

Find it here on MakerWorld hehe

The last one is the first version which is a lot more amaturish

For those who may be interested. I released it on Makerworld for free too haha

Every single mounting option is on the right hand side of the gantry and for privacy purposes I wanted it on the left to point into an empty corner of my room

There are some where they clip to the top but I wanted one afixed to the gantry that follows the Z Height like the right hand side mounts

Find it on Makerworld here hehe :)

This is actually only half of it, I need to make an identical one for the stick too haha.

I did choose to omit the center larger pad as there was no need and I wanted to keep the screw hole open for access if needed

Used: PETG for the main body, TPU 85A for the white pads

6 M5X40mm bolts to attach the main plate, angled adaptor and screw to eachother

1 M5x8 bolt to attach the disk to the screw

4 M4X60mm bolts to attach the controller to the mount (with TPU spacer for protection)