






Slimming engineer shaft DIY
Redwing 2966 about a month old. My skinny ankles and slim jeans just always had a something off. Decided to try and slim the shafts myself.
Started with the deconstruction, and appraisal.
Then overlapped the seams to see how things would sit. Once I was confident they would mostly line up, I started the center seam stitching using a basic saddle stitch. After that, just aligned the backstay and kept the outer seam original, and used a stitching iron to make the holes using the factory spacing. Saddle stitched that, and I successfully lost 1.2" on the inner circumference and my jeans will lay smooth now.
Because of the overlap, the shaft is a bit stiffer, and will need to break in again.