u/reddit_account_0x00

I had a bottle of 242 for some time and I found it to be green in color.

So I bought the siboor v0.2 CNC kit and accidentally glued one of the magnets to the metal door handle with the wrong polarity using super glue(I hate working with super glue). Is there any way to remove the magnet? I really like the metal door handle.

Which do you buy, bills, notes or bonds and what percentage does it take up in your portfolio?

From what I understand, it has 15 dynamixel servos(xl330-m288-t, can anyone confirm?) not to mention lidar and other sensors.

Some of the servos and 3d printed parts have quite a tight fit, I am afraid that I did not push them all in to the correct positions, how can I go about checking if I have done it correctly? What happens if the leader and follower arm do not match mm for mm? Do I have to be as exact as when assembling a 3d printer?

Its probably using an older firmware.

Which of ledger's lineup does not have this issue?

More specifically their newer models like the stax, flex and nano?

If yes, how would that work, suppose I use 2 out of 3 shares, do I have to setup 3 passphrases?

As I recall, there was an issue or vulnerability with the trezor safe 7 sometime back?

Does the new trezor safe 7 still contain the vulnerability or issue? Are there anything I should be aware of before purchasing it?

In fact, I find it's quite common for Singaporeans to adopt a patronizing attitude towards people with mental illnesses.

I find that it's easy to turn each frame joint about its pivot point even after using loctite thus losing the square during building. How do you secure the frame?

How easy or difficult was it to configure?

Btw, does the box turtle have a heater as well as an rfid reader for automatic filament detection?