u/timeforwasp

New set of SP pedals, power version. Been using SP since the dawn of time, still running X's on my other bikes.

After set up, I've got a clicking noise I can't figure out. Happens when I stand, and only one cleat (left. The Power one).

The plastic base plate is flush (used the "extra" one, included incase the standard one didn't sit flush. Sidi 43).

They are clean. No dirt, grass, twigs, newts, very small stones, anything

Used the longer screws to attach the cleat to the based plate.

Everything it tight. No play, wiggle, anything. Screws remain tight.

No gaps between the plate and base.

Cleats lubed with a dry lube (both sides the same. Again, only the left does this)

The LEFT is the cleat I disengage when I need to stop. The right is not really possible, due to an ankle injury years ago (and now total habit)

The pedal appears to be solid, not loose parts or movement in things that shouldn't

What might be the issue? They are secure, they work fine, the click bothers me.

Question:
If I go with the GT 10-48 and a 38 chainring, will there be an issue swapping in my 9-42 wheels?
Any issues with chain length? Wrap?
I could use my current 10-44 as my cassette for road, but I would really rather use the 9-42.

I set up a post to happen every night at the same time (I am the mod). In the body, I included a picture I'd like to show every night, as well. The post shows, but not the picture.

The very first night it posted, I got the picture on the front page of the group. Now, I can't see it unless I click on the post.

Is there a way to get the picture to be included in the recurring post on the front page?

Epic SPORT ANC3. Two different sets. I'll set the custom EQ, it's great, maybe it's there next time, maybe not. More than mildly infuriating.

Hope someone can point me in a direction.

About 36 hours ago, I got a very strong smell in ONE bathroom. Hard to describe, but I'm going with chemical, acetone-like. Totally out of the blue.

The only thing that is different in the bath is that an exhaust fan that is balky started to work after two days of not running when the switch was flipped. The smell is not a burning type of smell.

My first thought was fan. Turning it off did nothing. I got into the attic, directly above the bath, and the smell was not there.

I closed the bath door and put a towel down in front of the door. That isolated the smell, so now I only notice it if I open the bathroom door, but it is very strong if I do.

I have run water in all the drains to make sure the traps are full. No change. The toilet seems secure, no wobble.

Nothing is open, burst, leaking under the sink, in the cabinets, in the shower.

Very bad odor, one room only, bathroom, can't figure out the source.

Anyone have any ideas?