I am unsure if you simply get snips or similar to grab the head and pull it out, or they have to be drilled out? i need to remove a couple of panels to drill the stone wall behind. i do have some replacement plugs, are they similar to the car ones, remove the central pin then grab the shank to pull out the body?
Said machine, has started to play up producing a F02 error, which often seems realated to not draining. However the filter has been removed and cleaned. ( wasnt actually much in it ), i did i through clean a few ago, including taking out all the internal pipes as it was well clogged up. Now i do read that it might be a motor control board error too. Seem the f02 error also gets triggered if it doesnt drain a certain amount of time. Now assuming its all blocked up, why does it actually work if i cancel the error then throw in a manual spin and drain? hence me thinking back to control board. It seems to get stuck on the final rinse and spin. Any one offer any logic to this?
All of a sudden i cannot play any files from a usb stick, i tried2 different sticks, even bought a new one. Yes formatted to fat32 and files used to play off the same stick. It does show the files, but sorta greyed out and nothing is choosable. I am looking for the original remote so i can go down the firmware update but its worked fine for years. the tv works fine just the usb, any ideas?