Does anyone use these outside of babies with medical requirements?
We are looking at picking one up for our 3mo due to a few long ish car trips coming up.
However, I can’t seem to see a great deal of conversation or info about them and their safety. The only thing I can see is that theyre primarily designed to support children with medical issues that a normal seat may not do.
UK based if that means anything
Thoughts on them?
Hello all! 👋
I’m looking for some advice as my BF journey has not been a smooth one so far. I’ve just recovered from a bad case of mastitis (was pumping blood) and now my milk supply is at an all time low. I’m trying to pump as well as get my baby back latching… neither of which has been successful so far. Just stressful.
I previously used the mom cozy 5 in between feeds and used to get 30ml per boob, per pump but these became incredibly painful to use… I have since bought a spectra + but I seem to only be getting about 10ml in five minutes and then nothing else? I’ve gone in and out of massage mode to express following C1-C5 cycles/advice… but I can’t seem to trigger another let down. Has anyone else had this problem and know of a solution? If I take off the pump and hand express I can see that my boobs can still express so I’m stumped.
As a side note - I’m also taking brewers yeast, drinking lots of coconut water and doing everything I possibly can to get my supply up. Feeling very low at the moment seeing everyone being able to breastfeed around me and all the pictures/adverts online of people getting so much... I just wish I could give my baby the same 😞
Hopefully we can get some help, suggestions, or words of encouragement here for her. She shared this on a FB page and had no response.
Thank you all
About to buy my first ever printer (the one in the title).
Besides the printer, what else is needed?
I plan on printing miniature terrain and accessories.
- I’m thinking getting a range of nozzles (mainly want the 0.2 for finer prints)
- printing mostly on PLA for aforementioned prints
- do I need a PLA drier (UK based for weather related reasons).
Are there any must have additions I should think about adding to my bundle? I’m a complete nooob.
Thank you
With shifting priorities. When you activate the second and third struggle card. I understand that you too each activation to see which become the priority, but do you keep all the old ones active. Or are only the 3 highlighted on the card activate, and then potentially 2 of those 3 become primary?
Thank you!
Can you ever really shove a unit to a lower elevation. Shoved are range 1. All bases are bigger than range one, so therefore it would end overlapping the terrain, and therefore as per page 24 on the rulebook, stop so no part of its base is overlapping.
Is that correct?