Hello I'm trying to understand which endpoint the line from the top of the main hoop for the rule it is referring to with regards to an monocoque. Does the line intersect the midpoint of the attachment(where both the rear bracing and tube intersect) or at the very end of the attachment? (green or red).
Thanks!
Supports are falling off, the print is stringy as hell, and this is a new filament! Its pla matte filament and it has trouble with the first few layers i think and then the problems conpound into later layers
Something is seriously wrong with my PCB. The 1st time I soldered everything together the arduino IDE cannot detect my port when I connected it to my laptop. I'm confident it was working before I soldered it in. The 2nd time I bought a new Arduino Nano and made sure it connected properly before soldering it in, then the EXACT same thing happened and it won't detect my nano. This may not be relevant, but PCBS that I used before cannot connect to my laptop anymore(but too be fair those PCBs were pretty bad, however they worked once). At first I thought it was just a laptop problem, but I had a spare Nano that I plugged in and I connected to the port fine. I genuinely don't know what is going on but I will show my schematic, layout, and pictures. Is it fixable I don't even know(Also NOTE that the red leds in the arduino nano light up just fine so I know they're atleast working on the surface level).
I wouldnt have noticed if I didn’t break it in half to lower the dosage but im pretty sure its plastic. Is this normal Im trying these pills for the first time
Hey! Too be honest I really don’t like coffee(milk, sugar, etc doesn’t make a difference for some reason i just don’t like it). I’ve been doing research on alternatives and I found some people use Mio Liquid water enhancer Caffine. Has anyone tried this brand and if so do you enjoy it? Or maybe you guys have alternatives to both? I’d love to know!
For breakfast, do you guys just meal prep your eggs in advance or do you just cook them on the stove everyday for breakfast?
Wassup Reddit, I’m trying to make chocolate over night oats by using almond milk and cocoa powder. However, my cocoa powder wont ever mix no matter how much i stir it with the milk, meaning it has a settling problem where it just sits at the top and never mixes. Im just following a basic recipe on yt and bought 2 different cocoa powder but both have this problem. Am I missing something very obvious here? Thanks!
what should i do about my locs i want them to be in better condition if possible.
>!​!<This is my first tome making it. After i finished cooking it it looked fine but when I refrigerated it and opened it back up it looks like the sauce completely vanished. Did I do something wrong?
Do all the hole attachment points for Front Hoop and Main Hoop need inserts inside the holes? Does that mean the holes have to be slightly larger to accomodate inserts as well? Thank you.
Hello I want to know if these brackets satisfy rule regulation F7.8? I checked and it looks like its below midpoint of Main Hoop. I marked the dashed centerline as the midpoint.
F.7.8 Attachments F.7.8.1 Each attachment point between the monocoque or composite panels and the other Primary Structure must be able to carry a minimum load of 30 kN in any direction. a. When a Roll Hoop attaches in three locations on each side, the attachments must be located at the bottom, top, and a location near the midpoint b. When a Roll Hoop attaches at only the bottom and a point between the top and the midpoint on each side, each of the four attachments must show load strength of 45 kN in all directions
Hi, I'm trying to make my first PCB. Any and all feedback is appreciated. Software - EASYEDA
