u/Dev1l3d-Eg

Hi Reddit , my nozzle on my completely full can of spray paint broke is there anyway of fixing this. I would hate to have it go to waste.

Hello Reddit,
I was reaching out to see if you had any input on an Eagle Scout project I am trying to do. I had my Eagle project review, and they needed a few changes.
Identifying an adult who is familiar with woodworking/carpentry to review the project and help with the drawings. (I have a few ideas of people, but I was also wondering what you had to say.)
How will you join the boards/lumber for the project? (I was planning on screwing them together and using wood glue, a nail gun, and some metal brackets. However, they want some kind of woodworking joint, or something similar. I'm not 100% sure if that's even doable for this project or how I would manage something like that.)
Type of wood: lumber or plywood? (I was planning on using cabinet-grade plywood or something similar, but they said it is going to chip. Do you have any suggestions on other options I could use?)
I have attached photos of what I am trying to make and my dimensions.
Any suggestions or ideas would be greatly appreciated. Thank you!

Also, if it’s important, I have access to a chop saw, table saw, jig saw, and disk saw. Let me know if you need any other tools I might have access to.

Hello, my Oakley’s have some minor scratching and also this weird blob that I don’t know what to call. I don’t want to get replacement lens if I can avoid it.the blob makes you feel like I have a cataract. I can live with the scratches but the blob is annoying does anyone have any advice for me?

Hi I know I have been posting on here a lot lately but I hope that this is my last issue. I am trying to change the offset so it prints in the center. I know the probe is -25 mm from the nossle with 0 x offset because it is right behind the printer. I am using cura and have tried changing the firmware probe settings (mriscoc) and in cura and no matter what I change it prints the in the exact same size and spot even after reslicing the print plate. Does anyone have any advice or good videos to follow. Maybe they have offsets for a stealth burner on a cr 10? Any ideas would be nice as this is the last step before normal printing. Thanks in advance :)