Coming soon. Universal magnetic 3D printed mag pouches. Fits everything from a skinny CZ up to a 2011. Should halfway through the R&D process - finally ready for two of us to run them in a match next weekend. The files will go up on both Printables and Makerworld.
Dried for 30 hrs @ 90c. 300blk profile slightly modified: 270/285c, 70c bed, P1S, 0.4 nozzle at 0.16 layer height.
By failing to do any work on the gullet, you end up as photo 1. Too high, blunt top plate. No hook.
By watching too much Buckin’ and obsessing over the gullet, you get too deep and get underneath the top plate like image 3.
The correct answer like all things in life is a balance. The angle of the top plate is more important than the gullet.
Cajunized and direct-milled CZP09. I slapped the short-reset kit into it and was arrogant enough not to test fire it.