Is there any node in comsol to model the thermal connection resistivity between 2 shells? I used the thermal contact interface, but this is just model the thermal contact between layers in a single shell.
Hi everyone. I have calculated the trajectory of my satellite from GMAT software. Unfortunately, my satellite has a complex geometry. I cannot calculate the view factor by using formular. Ansys speos is a very useful tool to calculate irradiation. However, I don't know how to model solar, albedo, earth irradiation verus time in this software. Before transfer to ansys mechanical to simulate the temperature.
Please suggest me if you know!
Hi everyone, tube lens is know as a component to correct infinity of objective into a sharp image. Current I am working in a maskless lithography. I want to convert light from the projector in to the infinity microscope using throught lens tube is reverse mode. Is this possible?
I know lightsource from DLP projector is not a point so it is difficult to create colliminated light source. But is there is any idea, please suggest me!
I know lightsource from DLP projector is not a point so it is difficult to create colliminated light source. But is there is any idea, please suggest me!
I have a driver and a controller in my lab. I dont understand why my laser cannot turn on. Even I turn the current source up to 2A. It still cannot turn on or warn up.
Two images show the same component, in which I removed the plastic cover in the second image. My sawing machine is working normally, and then it burns. I open the cover and see that this component is burned inside. Does anyone know this component? Please let me know.
I have many loading settings in ANSYS Mechanical. Is there any way to create a different color for it loading? It will significantly improve my report.
I wanna to thermally couple between a transparent substrate and a transparent sensor. Any suggestion for me?
What should I do, mesh the bolt in this case, or remove it by replacing the RBE3 elements? I want to simulate the process of heat transfer in the frame.
Normally, in structured analysis, people will use coupling elements to connect between 2D and 3D elements of a part for complete structures. But I realize that we cannot do that in CFD, they don't have the coupling. So there are two strategies are: meshing by 3D elements only or by using the interface between meshes. What will you handle for this case, senior CFD users? Please give me the advantages and disadvantages of each method.
