u/Gunmonkey5

Initially, after shooting the weapon for sometime, I noticed the headspace was very tight 0.012 so I got +6 rollers and a 90° locking piece for my full-size. Today I went to test it and was zeroing it with 124+ P Winchester Ranger I was yelling it and noticed that it was flying probably 7 to 10 feet to my right. I had a double feed where a shell casing fell back into the gun and seized it up. I disassembled it and cleared it out, but when I reassembled it and continued shooting the occasional casings that would eject would essentially fall right at my feet and then 80% of the time it would have a failure to extract. What happened and what is going on?

——UPDATE——

Yall are the bomb. While I appreciate all the help and support the extractor spring is bent. I’m not a go armorer but I know the extractor shouldn’t jiggle and be loose. I have extra extractor springs on hand. Taking it back tomorrow to test. It makes sense because after the jam, the ammo that used to fly 10 feet away was plopping at my feet if it ejected.

Long story short expresslane who manages the va express lane says that I didn’t pay a toll on 95 SB and they sent me a letter with my license plate. I call them and they say I owe the toll of 5.05 plus 15 in admin fees. They also say they work with ez pass but are a separate entity. I told them that my account is on auto renew and I have a primary and secondary credit card on the account so it’s impossible that my account balance was zero like they said. Ez pass also confirms there was money in my account at the time and is sending me a letter. They won’t waive the fee even though it wasn’t my fault, ez pass says they dont dispute claims, I don’t want to pay 4 times the fee because I didn’t do anything wrong. Any help would be wonderful.

Alright guys I’m legitimately stumped. I have a atrius super selector, adjustable gas block on a 11.5” sbr. Gas open wide and using a h2 buffer with the Geisselle 42 h1 buffer ( weights replaced to be h2) and the braided spring. With a normal spring it does maybe 1-3 round bursts. With the braided it does 1-2 shots consistently. With a suppressor it’s flawless. I swapped it to a normal carbine buffer and it obviously doesn’t work at all. I need help yall.

Long story short I have a 5.56 sbr. In the 10.3 config with 55 gr 5.56 soft points I’m getting an average of 2563.1 fps. Swapped the barrel from a Daniel defense to a rosco 11.5” and got an average with the same ammo of 2636.6 fps. I’d rather be shorter than longer (first time I’ve ever said that in ref to length. But if that 73.5 fps difference is more beneficial than length I’ll keep it. Someone please help unfuk my brain. Thanks in advanced.

Sorry should put it’s for HD/ general training and I’m running this suppressed.

- Your typical overthinking Asian.

Ok guys. So I had a 10.3” that with a suppressor ran beautifully without I could not get it to function with even a h buffer. I swapped it for a 11.5” now with a h2 or h3 buffer and an adjustable gas block. Best I could get is a 2 or 3 round burst followed by a dead trigger. I’m trying a 5.9oz buffer next but I need help. The adjustable buffer when turned down won’t work even though in semi woks fine. It’s an atrius super selektor for reference.

I haven’t changed anything except do the barrel. The bcg, changing handle and everything else is all the same but a different barrel and adjustable gas block.