Login

u/InvestigatorOk2808

r/IronHands40k r/anycubic r/AnycubicOfficial r/3DprintingHelp r/resinprinting
▲ 25 r/3DprintingHelp+2 crossposts

All of a sudden z-banding

Good morning. I’ve had my M7 for about a year and half and have had really good luck with it. Prints have been smooth with issues steaming from supports. Recently I have been getting some pretty gnarly z-banding and can’t for the life of me figure out a fix. I have tried wiping down the z axis bolt and re-greasing. I have tried upping my times for the print to wait before and after layers. But I still can fix the issue. Also, I have noticed a clunk sound whenever the build plate starts a decent to start a print. Any suggestions would be much appreciated. Included are photos of prints from this week.

u/InvestigatorOk2808 — 4 months ago
▲ 31 r/IronHands40k

Iron hands techmarines

A question. I assumed tech marines were red regardless of the chapter but with the introduction of the iron hands in Space Marine 2 and the tech priest skin being black I have started to question my logic. Anyone have thoughts on this?

reddit.com
u/InvestigatorOk2808 — 5 months ago
▲ 2 r/anycubic+1 crossposts

Ok if this is not the right place please ignore. I’ve had my M7 for a good part of a year and all of a sudden I am having failed prints where some pieces are not adhering to the plate. From what I gather it’s a leveling issue. I follow the instructions per the video (loosen build plate hex screws, place two sheets of paper,press home, press the two smallest increment down buttons once each, press on the plate while screwing build plate screws tight, perform a successful level check). But still can’t get consistent success, and have the same missing parts of print issues. Am I forgetting something or is there a trick anyone has come up with?

Thank you in advance.

reddit.com
u/InvestigatorOk2808 — 6 months ago