u/Jumpy-Use4502

Im upgrading my studio and debating my oxy options.

Do I upgrade to bigger Cons, do I go for a homefill, ect.

I have been running a Bobcat on an EX-5 (7psi/5lpm) and thats been okay. But I want a set up I can grow into and can handle a bigger torch. Im not getting a new torch right now but Id be looking at a Bravo or a Phantom in the future. Can a Bravo run on an EX-20 (20psi/10lpm)?

From my research it sounds like I'd need tanked for the Phantom, at least the outer fire- but would the inner run on my EX-5?

Ive heard a bit about HVO/HVLP/ect and am intrigued but not mechanically inclined.

Im still tweaking my kiln temps. I was aiming for a contor fuse but wound up with a hard edge tack.

If I run that same piece again, do I need to up the temp to get it to flow more? Or is running it up to the same temp for a second time going to get the glass to flow more?

Is it just temp, or hold, or both that create movement in the glass?

Anyone play around with fusing numerous layers? I know the results could be totally wonky but Im thinking about trying to form something more 3d & sculptural. Im going to cut and stack shapes maybe up to 6 layers at certain points. I want high points and low points. My goal is to tack fuse it all together and then slump a sheet of clear over the whole thing. Going for abstract landscape vibes 🤷🏻‍♂️ Im not terribly sure how I want to run the kiln but I think in general Im going to go low and slow, I dont want a puddle of full fuse.