u/Krsok

This is a compact, light and minimalistic Flashlight Mount meant for Airsoft Replicas.

This mount fits both M-lock and Keymod handguards and flashlight with 18 to 25mm outer diameter.

The mount also swivels, so it can be quicly and efficiently adjusted to the operator's prefrence.

Files are currently up on my cults3d page, link in comments!

Hey everyone, this is my 3D printed RGM-40 Kastet replica.

The replica works with standart 40mm Airsoft Gas grenades, lenght/capacity doesnt matter.

It features a working locking mechanism to retain the grenade inside the barrel, a working release latch and a working safety lever.

The replica is 1:1 scale and 95% accurate to the real deal

For anyone interested files are avaiable on Cults3D, Link in Comments!

Hey everyone, this is my 3D printed RGM-40 Kastet replica.

The replica works with standart 40mm Airsoft Gas grenades, lenght/capacity doesnt matter.

It features a working locking mechanism to retain the grenade inside the barrel, a working release latch and a working safety lever.

The replica is 1:1 scale and 95% accurate to the real deal

For anyone interested in the files, feel free to hit me up on PM!

This is my 3D printed Co2 powered airsoft Mortar.

It features a foldable bypod, moving base plate and adjustable dummy sight.

The mortar works by installing a 12gr Co2 cartridge inside the shell and then dropping it in the barrel, where it gets punctured by a sharpened m4 bolt at the bottom and flies off.

The range is heavily dependent on the barrel lenght, here are the results i have:

With a 75cm barrel, during testing the shell flew about \~50m (\~165ft)

With a 120cm barrel the shell flew about \~80m to \~90m (\~260ft to \~295ft)

P.S. Range may vary depending on shell weight, print quality, temperature, wind conditions and barrel lenght.

Here is a link to a demo video for the ones, that want to see it in action!

https://youtube.com/shorts/u1NAagGkK

If anyone is interested in the files or has any ideas/suggestions, feel free to hit me up on PM!

Hey everyone, i just wanted to ahow you guys my 1:1 scale, 99% metal Maxim M1910 (H?)MG. The replica does not yet have any internals, but will use Polarstar HPA engine, standart M4 hop chamber (Maxx Hop) with a PDI inner barrel. The BB's will be fed from a real 7.62x54R Maxim ammo box via a G&G Box Mag internals. The Reciever (Body) is 4mm thick steel, the water jacket is 6086 Alluminium, the small details are 3D printed from PETG at 100% infill.

What do you guys think? Any tips for improvements?

I was thinking on making a few more and putting them up for sale, how much do you guys think would be a fair price?

Thanks!

Hey everyone, does anyone happen to have some tips and tricks for making 3d prints look like cast metal like in the picture? I am currently experimenting with fuzzy skin, but the results so far have been so-so. I tryed some online engines for texturing the model, but every time i export it and load it in tinkercad or bambu studio, it just makes my model low-poly and gives it some random bumps. As of post processing, i just use some primer, paint and a matte clear coat.

Any help would be greatly appreciated!

Thanks!