u/LF-badd

For a little bit of context I took the rear wheel off to get the tire changed and when putting it back on, had some issues with the break not having any pressure.
Bled the full system and then it had pressure.
Pried the pads apart, or emailed to the caliper, push the rear break a couple times and they compress and have force, but don’t retract all the way.
They end up dragging on the rotor.
Enjoy my video hahaha.
Any help is appreciated greatly!

I have a w204 C280 2009 model. On my dash I get the notification, 'Left dipped beam.’
From the front, it flickers.
One person said it's an LED projector and it's carked it, one said it may not be grounded or it's an electrical issue.
Is this just a bulb? Or a projector module or?
Attached is the video of it flickering.
I’ll try attach an image of the back of the 'module/ bulb' inside.

I have a w204 C280 2009 model. On my dash I get the notification, ‘Left dipped beam.’
From the front, it flickers.

One person said it’s an LED projector and it’s carked it, one said it may not be grounded or it’s an electrical issue.
Is this just a bulb? Or a projector module or?
Attached is an image of the back of the ‘module/bulb’ inside.

I’ll try to add a video of the actual light in the comments, as stated it flickers.

I want to replicate this cut. Just getting into the sticker game, I’m assuming this was cut from a larger sheet? I’ve tried getting quotes from others about printing this, but they don’t seem to cut to precise shapes?
What would this process be called to do this?