u/Luiml73

By next week I should be able to drive the 1/64 PFV Rc cars using my Steering wheel and pedals.

Hey guys, So I went to turn on my rig and set up a lan for when my son comes to visit and the pedals on my R5 are no being detected. Last time I use it was about 1 month ago and it was working fine.

I have tried all the software updates recalibrating the wheel and nothing. I did notice the RJ4t wire on the brake side was being pulled a bit to one side. I took a few pucs and AI says one of the pins on the throttle RJ wire is bent. It looks fine to me.

Ehat are my options here. Would biying just a used brake pedal.on ebay maybe get me.driving again?

Thanks

So you guys mentioned In my last post that I needed a step up regulator so I got one. Nlow I just need to know where to solder everytthing. Power already comes directly from the cars battery. If its not too much trouble someone might draw a diagram with paint using this image so I can take to a phone repair guys to solder it for me. Those guys use those microsxopes to solder and here in Colombia probably charge me $5.00

https://youtu.be/Hem5t8T4WoI?si=2u66L\_ylCOp4HSLC

Render of what it should look like when Im done.

Thanks again

Some of you guys helped me out a few months ago with questions I had about my streets for my 1/64 scale city.

A few asked me to post a vid when my project was done. Well its not done yet but Im trying to open a location here in Colombia with custom Hotwheels tracks and a city where kids and adults can drive rc cars through a minature city.

Well the second question on the mall application was lets see your social media and I didnt have one so I had to open YT channel and next an Instagram and Tictoc.

Anyways thanks for all thr advice and here is a small vid of how its going. Maybe a like would help but you dont have to.

https://youtu.be/Hem5t8T4WoI?si=JVoei\_DuudEb3gIQ

Thanks again

Luis

Ps: Went to bed last week and left a print wityh some dry silk filament and woke up to blob of death. It burnt the toolhead PCB board. New one comes in today

Hey Guys need some help from your pros. So I build my son at hotwheela track and I had an Idea of being able to watch the racing live with fpv goggles. Ive never owned a drone so I know nothing about this. Chat gtp said it could be done so I bought these compents.

​

1. Is it possible at all and if so am I missing something?

​

2. The camera and the vtx are digferent barands and the plugs are different so i would have to solder.

​

3. If in fact it is possible and I have everything I need. Where do I solder the battery to the board to give it power?

​

Thanks

​

Luis

https://vimeo.com/1201481824?share=copy&fl=sv&fe=ci

Left it printing overnight and woke up to a mess and an error message. I cleaned the bed with alcohol but I have not been able to get a clean print again. I did multitool head calibration and bed leveling twice. Any suggestions?

Nozzle temp 220 and bed 65c

Hey guys. This is my very first print with the U1. Now I only need the top center lines paibte white and the edges. But for some reason Im getting 14 filament changes and I see in the preview its trying to print some inner sections white also.

Any suggestions and how to fix this?