Hi everyone,
I just got a house that is over a center old! I was testing everything for lead paint with those q-tip testers that you wet and rub on the surface. While testing the ceiling in my upstairs rooms, the popcorn ceiling just basiclly disintegrated. I didn't test any other areas and the tip was just all white so I couldn't get a read onit. Would you guys be able to confirm if this abestos?
Hi everyone,
I am looking to cut a tree in my backyard. I have an electric branch trimmer from Aldis and Ridgid chainsaw but it isnt long enough. I am looking into getting the following saws and would like to get your guys opinion on if this will get the job done.
Jameson Rope Sniper
30 ft Telescopic Manual Pole Saw for Tree Trimming & Pruning
Husqvarna 525PT5S
Any tips would bw greatly appreciated!
Hi,
I found an old OG Xbox and want to try it out but I am missing the correct power cable. I have a power cable that is flat on one side but wouldn't fit. So I cut the edges to make it a figure 8 and now it fits perfectly. Before I plug her in and play a few games, I wanted to check with you guys before I plug it in because I am worried I might fry it.
Thanks in advance!
Hi everyone
I am having a hard time finding the right product to fix my screen door. It is the thing that holds in the glass on the screen door. I purchased the following but it didn't seem to work out. Would you guys have any recommendations besides tape lol.
https://www.walmart.com/ip/47663376?sid=92523016-a6f4-41e1-9364-07210c394b56
Hi,
I am changing my girls oil and haven't jacked up a sedan in a while and wanted to confirmed his is the correct spot to jack it up by?
Nissan Sentra 2016
Thanks in advance
Hi everyone,
My wife saw a possum out back so I grab my tried and true Crossman Quest 1000x, she is an old girl but I can shoot a tennis ball from 40 yards away with it. Unfortuantly for me, but fortunate for the possum, while grabbing it I dinged the sights on it and now I need a new one. I cannot find a direct replacement for this. So it seems I need adapter to put on a rail and maybe a scope. Any recommendations for the rail adapter and a new scope?
My grandfather gave me this gun and I already replaced the spring on it. I dont mind spending some money on this to get the best for this because I know that is what he would want.
Thanks in advance!
Hi everyone,
I just installed a B2202 Chamberlain Garage Door Opener and after Following the instructions to the T and it wont work. When I try to open it, it just blinks twice. According to the manuel, this should be due to the sensor. The following is directly from the manual:
"My door will not close and the lights blink on my opener:
The safety reversing sensor must be connected and aligned correctly before the garage door opener will
move in the down direction.
l Check for binding or obstructions anywhere along the track to garage floor.
l The safety reversing sensor must be connected and aligned correctly before the garage door opener
will move in the down direction.
o Verify the safety reversing sensors are properly installed, aligned and free of any obstructions.
o If the receiving sensor (green LED) faces direct sunlight, switch the receiving sensor with the
sending sensor so the receiving sensor is not in direct sunlight."
I have checked the wiring for possible staple damage, no damage found. I cut the sensors wire short, faced them directly into each other, didn't work. I purchased a new sensor and installed them didnt work. NOTHING IS WORKING!!! Last thing I read was that it maybe a logicboard problem but before I go that route, I want to see if anyone here had this issue and can help me out?
Thanks in advance!