u/Set_It_2_Wumbo

Two Nega’s within 2 years?? Both the game and episode special were absolute fire, tho. 🔥🔥

Popcorn bucket do be looking good by the toilets. Should have left it here after the movie.

Retraction issue? I’ve dried the filament from 8-12 hours. PETG filament on a Bambu P2S printer. I’ve slowed overhang speeds to 5mm/s on that ramp up to give a good bottom without support. My guess is the acceleration back into the normal print speed may be doing this?

2008, my best friend and I are in 7th grade English class. We did reading time where we could read whatever book we wanted. I didn’t have one one day so she lent me her twd comic, the first one. She was already on the second. We ended up both loving them for how gross they were and how they kind of helped our morbid curiosity

2010, Halloween. We spent months excited about the episode, but it didn’t come out until 10 pm. So we went to a haunted house and did a little trick or treating.

Then, 10pm rolls around, we’re at her house with snacks, ready for a sleepover. The first episode was amazing for us, because it felt so much like the comics we read, down to the casting. It’s one of my favorite memories and kinda blows my mind that it was 16 years ago

Apparently I never looked up in my many reruns. Beautiful irony.

I got some interesting spider cocooning around the supports. Only showed up after turning off z hop, I’m guessing there’s not enough snapping to reduce spider webs. Any suggestions?

I turned off z hop to initially remove oozing 2mm nubs at finished layers without relying on very large retractions… is there another way to work around this issue?

PETG at 255C on modded Klipper CR-10 Smart Pro.

Retraction at 1.2mm at 35mm/s

Travel speed at 260mm/s and acceleration at 5500mm2/s
(2hump frequency inputting shaping on y-axis, upgraded 2A Bedslinger motor, no ringing)

Dual 5015 fans at 90% cooling, which I calibrated at my max flow rate of 22mm3/s CHT Boteck nozzle as optimal for overhangs I’m not using supports on at 225mm/s max print speeds. This cooling speed gave me no issues on the print itself.

Pressure Advance can be a little better (0.06), but I don’t mind it within this imperfection range.

Support interface density and z / xy distance are perfectly tuned for support removal, but the webbing makes it look like doodoo.

Any recommendations welcome, thanks!