
Spot on Pixels mouth
Just noticed this spot on the edge of my Jackson's mouth. No idea what could cause it other than an insect bite. Anyone ever encountered anything similar?

Just noticed this spot on the edge of my Jackson's mouth. No idea what could cause it other than an insect bite. Anyone ever encountered anything similar?
At roughly 5:30 PM on 126th East Bound a kid (17 - 20 with a buzz cut) trying to pass cars by driving between them, (splitting lanes) doing at least 70mph then cutting the car off intentionally as close as he possibly could. He did it to me, then immediately did it again to a truck in front of me. Couldn't get his plate # because an emergency vehicle came up behind us at the light. If you encounter this person, get his plate & report him for reckless driving. He is going to hurt or kill someone.
Best live show(s) I've seen in my life. Love these guys.
No, this isn't about Sir Rodrick, first & foremost. I discovered this car had a stage II Tuff block from IAG when I first got it. I know IAG blocks are louder than stock, but I have no clue if they installed upgraded heads/valve train components along with the block (to me, it sounds like it, but I don't have much to go on). Anyone with experience have any input on how to determine if the top end is upgraded as well or even if yours sounds the same?
Several ideas what it could be, but absolutely no clue for sure. Seems like steel or iron, but is not nearly as ferrous as it should be for steel/iron. Magnet sticks, then slides off if upside down. What is it!?
Independently needy
My Jackson's Chameleon's enclosure
Then the SRS Airbag system decided it wanted to be the problem.
So, Google failed me. Hopefully Reddit will not. I have been searching for boost leaks today & I think I finally found it, but based on the interwebs, it's left me unsure. Anyone with experience on their vacuum pump leaking during smoke testing? In my opinion a vacuum pump should be sealed... otherwise what is it even doing with it's life? Do your thing Reddit.
Got sick of looking at that ugly intake manifold on the FA & refuse to pay $200 to buy a cover, so I designed, modeled & printed a cover.