Why is it sometimes my printer prints flawlessly like the first picture. Then there are times it prints horribly like the second picture. What can I do to make sure I get flawless prints everytime?
Just installed a new motherboard to my 3D printer, I found this part on the table after I lifted it. Where does it go?
This is my first time using a 3D printer so this is all new to me.
The patience and waiting is finally paying off. 125 days later my hair is now at a point where I can style it and see great improvement. I had an HT on my receding temples and crown, the crown is growing but progress seems to be much slower. The receding temples area is looking great for 4 months, I'm waiting for the rest of the hair to blossom and to thicken. At the moment I can tell when I'm directly under a light I can see that the density on my temples is thinner than the rest of my hair. I've noticed when I'm not directly under a light or when I have hair product in my hair, then density doesn't look like an issue. I'm tryna be completely honest with myself and not accept anything less of what I wanted and expect. I will say that with where my hair is at today my confidence is growing, and I can't wait to see the final product.
I think at the 1 year mark I'll leave a review explaining where I got my HT done, so far things are looking on the up.
Good luck to everyone else currently on HT journeys, hope you all are happy with your results.
When I go on cruises I usually pack like I'm going to the beach but I have a feeling this cruise will be different.