u/techmagnet

You guys wanted to see temps. Well we had to improve vram cooling. For that as the levels are very different, we didn’t integrate it in the waterblock. So we had to cut the original cooler and get the vram part off. It would be also possible to mill this form copper, but too much work for no reward 😂 temps as stated around 20 degrees less, but today also the AC is not working. So at the end you will see in best case scenario around 20-30 degree maximum less compared to stock, depending on fan speed. Next step integrate pump in the cube and make it smaller with hard tubes. Overall runs cooler and more silent.

You guys asked for the video and more infos on the waterblock. Waterblock was made with the carvera air, which is a budget desktop cnc. That’s why the quality isn’t super good, but that’s all we have. Need to open it again and work now on the vrm cooling which is quite challenging as the mosfets are super tiny… and also they run quite on the limits of thermal design which sucks

What’s your opinion guys ? Atleast we did it faster than jayztwocents 😂