u/-Seether-

I'd like to ship some of my potatoes to friends in NC & I'm in PA. Is this a bad idea? If not, what are the best practices so they don't spoil in transit & is ground shipping ok?

Pinion gear in my omni terminator came off and their solution was to SELL me another one. Hard pass on anything made by them. Buyer beware

My pinion gear popped out of alignment. I shoved it back in place (grub screw won't budge) and that worked for about 3 seconds and then the pinion gear decided to not want to be part of the truck anymore and ended up on the blacktop.

I can shove the original pinion gear back in place, but the replacement that the truck came with will not go in all the way.

I've contacted customer service and they are useless so clearly they don't stand behind their product.

What's the trick to get the new pinion gear in there and also staying in there?

Steering & lights work,but won't go forward or reverse. Esc is blinking red. It just stopped responding in the middle of using it.

How to fix?

Steering & lights work,but won't go forward or reverse. Esc is blinking red. It just stopped responding in the middle of using it.

How to fix?

I've tried 4 prints so far and nothing is going well. Using PLA filament. 1st two prints came out a stringy mess. Last 2 tries did not print anything at all and gouged a chunk out of the base plate.

I used the temperature settings for PLA per the Qidi manual.

How should I go about fixing this? I'm at the point of just selling it and calling it a day.

I've tried 4 prints so far and nothing is going well. Using PLA filament. 1st two prints came out a stringy mess. Last 2 tries did not print anything at all and gouged a chunk out of the base plate.

I used the temperature settings for PLA per the Qidi manual.

How should I go about fixing this? I'm at the point of just selling it and calling it a day.

I've tried 4 prints so far and nothing is going well. Using PLA filament. 1st two prints came out a stringy mess. Last 2 tries did not print anything at all and gouged a chunk out of the base plate.

I used the temperature settings for PLA per the Qidi manual.

How should I go about fixing this? I'm at the point of just selling it and calling it a day.

This is the second time I've tried to set this thing up and it just stays on the screen forever and nothing ever changes. How do I fix this?

So far, the raspberries that have ripened for me this year have been very bland tasting. The plant is three or four years old and has been great up until this.

​

The only thing that changed, aside from the plant being a year older, is I started using Miracid fertilizer. Should I stop using it?

It's early in the season, but the raspberries I've picked so far have tasted watery for lack of a better description at this point. The taste is not as powerful as it has been in years past. This is the only raspberry bush I have so I don't have other ones to compare to right now.

​

​

Wondering if there are any must have accessories or extra parts to have on hand. I will be printing with PPA-CF.