
Printer stops extruding
supposed to be 4 in the picture, barely made it past the 2nd. I already checked for nozzle clog and did a cold pull, not sure what else to do
a1 mini printer

supposed to be 4 in the picture, barely made it past the 2nd. I already checked for nozzle clog and did a cold pull, not sure what else to do
a1 mini printer
hey everyone, not sure if this is the best sub for this but it is only with undertale music sooo
I see many videos that use undertale music in them, even full undertale playthroughs. they don't have any copyright issues. I upload a YouTube short that uses 2 undertale songs, and it instantly gets taken down due to copyright. I appeal the claim after doing research and stating that the copyright holder allows the use, but it gets denied. I emailed the copyright holders and am waiting for a response.
how do I get past this? I don't want to risk getting my channel deleted over some crappy copyright stuff
I want to post a full playthrough but am scared that the copyright could end up giving me copyright strikes
I love this makers style, but they don't sell 3d models are there any models similar (and more feline if possible)that any of you know of?
thanks!
don't mind the bottom tier
I am struggling a lot with this dive. whenever I try to get into the pike or even twist my body for the last half, my legs and entire body other than my torso don't cooperate. I end up with my legs in front of my and my torso at a 45 degree angle towards the water
I attempted the dive into a foam block pit, and every time I was able to go over and land on my stomach with my legs behind me. a couple times I was nearly in a pike but facing the blocks.
I think that I am able to stay hollow when doing dryland, but instinctively stay archy when doing it for real.
any ideas?
I was trying to recreate a song by copying an existing fl studio project into my own by hand (so that i can understand what everything does), but i notice that I can never get this (the little lines branching off to the side of the main down arrow). what does it mean? and how do I do it?
been using this for months and still can't understand a single thing
really confused on what some parts are supposed to be lol
extreme demon difficulty
​
ship part sucks ahh
​
I want it to be fun gp but hard
I don't have a bearing removal tool, and the pliers don't seem like they are working. any tips?
I couldn't find any eggs, ig they were all chilling here