u/Fluid-Pangolin1993

https://preview.redd.it/mbesmqj049ih1.jpg?width=3072&format=pjpg&auto=webp&s=e3a69c1b674382002d81a3ba97bcf607383d440f

this is the fuckup by not aligning the nub on the end of the press.

this is my solution only downside is that it required a little bit of intelligence to use properly

credit to the honda civic guys, i broke down in my obs chevy kindof out in the sticks, i had a leaking oil line for the cooler i could patch it up no problem. and a guy in a red 99 civic pulls up and drives me to the orileys near by to get hose clamps and a new barb fitting.

i kindof officially want a civic now, bcus the community irl is very nice.

manual swap working out the kinks. putting on finishing touches..

nv4500 from behind 6.5 1992 obs 2500. put into 1991 gmc k1500 spicy heads cam all that bs.

she runs good, gets up and out of her own way when i ask her to.

has anyone done something better than, self tappers to hold the top corner of the clutch pedal bracket up into the dash, are there any known products that let a guy bolt it in?

because i went to start the truck in reverse, i had parked on a hill. and i was holding the clutch down as far as i could, but the engine wouldnt spin up fast enough to fire over, ( it made an unhappy noise coming out of reverse and fired right up in neutral right after)

when i hit the clutch i think the bracket is bending down bcus my self tappers fell out, and its not allowing the full travel/ and label to ruin my 2100$ transmission rebuild,

thanks gmt400 community as always

im dealing with a thief in the shop.

first it was a pair of klein strippers, then the company provided icon allen/torx kit, so i buy one of my own, write my initials on it in big yellow letters, after this weekend its gone.

there is a weekend crew that i havent talked much with, and there are guys on other shifts that i know pretty well. 3 of which think its one singular guy. kind of guy that watches netflix on the clock. some of the guys on the other shifts come in on weekends for extra hours. including mr nexflix.

is this a go straight to the supervisor or hr, type thing, or is it a, set up a camera and get proof, thing? ive spent upwards of 80$ replacing tools that have been stolen. including the new kit i got just to use as bait.

im looking for the whole danm balancer assembly for a 2001 toyoya camry with the 2.2 5s-fe engine. i have to pull the pan for an oil leak in the gasket but the tapping i hear i think its likley the balancer assy.