previously i was printing in 0.27 layer height and 0.2 line width, holes look less oval, was still oval
Is it because I don't have enough voltage on my motor? It's my guess. When change to 250mm it works fine
I'm doing a 3d adaptive clearance then another with finishing pass. However finishing pass takes like 10hrs, what am I doing wrong? The stock to leave to 0. Or should I use another? I'm building a wood speaegun and it's more complicated piece 2d seems very hard to use
It's my first CNC project
i have Aspire, it works well . z0 is z0. however hwen i load gcode from fusion360 it starts first high and hwen it goes down its usually way above my material, around 2mm. anyone to set this on fusion360 to start all my project with -2mm?
More for fun, than anything. anyone tried something like that? cave and night would be pretty advantageous i think, where u dont need lots of range
a short bolt, like a crossbow would it do better? less weight faster penetration - small shaft on a pistol size speargun, thinking 2 band 16mm or 3.
20-30cm barrel length, can be roller
I got to try femobook today , and was impressed. But never had chance to try niche zero, anyone has info? I'm visiting Taiwan and both are at the same price, nich zero being 4 yrs old, and femobook is brand new ..how does taste compare?
Workflow seems to.me femobook might be better easier to clean
