
Anyone else have one of these?
It's a spectralight cnc lathe built on top of a sherline. It looks to have been redone by forest scientific.
Thought her on Facebook marketplace so I don't have the original PC or control software. My understanding is that foredt scientific's velocity CNC software is basically just a reskin of centroid, so I downloaded cnc12 and have successfully connected to it and it said it was updating the firmware, but I haven't been able to jog any axes or anything because it says the eusttop is being held down.
And the configuration wizard it doesn't show any of the safety inputs or any inputs at all connected to each i o, so I think I will need the config file from Forest scientific. I can probably hopefully get that from tomorrow but just thought I would check here to see if anyone has one of these and has any advice or can help me at all.