




Update on adhering foam to spandex/nylon/gymwear
After MUCH fooling around to get eva foam to stick to a spandex/nylon blend piece of gymwear I finally hopefully have found a solution.
As long as you’re not going to reuse the piece in question.
Stretch it out over an object, then rough up the surface with some sand paper. Then, prepare your contact cement(weldwood) on your foam - I’ve found putting a good amount of it works well. Once it’s tacky, place it on and hold it for a few minutes. Then leave it alone for a while. I waited about an hour before inspecting it. After a bunch of stress testing the object it’s still on there :).
3m max strength also works but is quite messy. But if trace out and caaarefully spray, it’s done very well holding.