What to do with these?

I do government and closeout auctions. These came with a lot I acquired a couple weeks ago. They are motor controller panels I think. Have Google lensed them and came up with new boxes at around 5k usd. I have 5 of these 2 dont have doors and 2 the outside plastic box holding a circuit board I think is broken. Would these be something I could sell to an eletrical supply place that buys new and used equipment. Are they worth anything to sell or just scrap.

If this isn't appropriate for this forum please delete. Trying to figure out how to go about these.

Thanks

u/Vivid-Car579 — 30 days ago

Help dont know how to go about this.

I have been getting calls from credit one bank. I have never opened a credit card other then capital one. They call me about 10 times a day about every hour sometime more then a couple times an hour. I had gotten into a bad break up with an ex and a whole bunch of my passwords changed and other stuff. I answered one time one of the calls they say I owe them 300+ usd even tho I have never used said card or never tried to obtain one from this institution as well. I think she had gotten my social and other things and made an account and was using the card (my most honest guess since there was a card open in my name). I told them It was not me that created an account and to stop calling me this was a minth ago they call sometime 20+ times a day. I block every one and they make new numbers different area codes ect. What can I do about this if anything can I sue under the spam act to get them to stop calling?

reddit.com
u/Vivid-Car579 — 1 month ago
▲ 53 r/ScrapMetal+1 crossposts

Scored last night

Commercial building is getting a total remake inside. Got some copper pipes as well. Got all from roll offs.

u/Then_Marionberry_259 — 1 month ago

Would this be clean or dirty aluminum

Got a couple hundred pounds of this wanted to see if it would be considered clean or dirty aluminum sheet. Little bits of paint on some of them here and there. I have more then what's in the bed just wanted to see what it would be before taking in. All aluminum.

u/Vivid-Car579 — 1 month ago

What would this be classified as

New to scraping what would this load be categorized at?

u/Vivid-Car579 — 1 month ago
▲ 1 r/help

Video not uploading

Trying to add a video to a group to ask for advice and it gives me an error message which I am following all the way to upload right due to the rules and it keeps saying error. Its 7mb and a mp4 file not 15 minute and more then 2 seconds.

reddit.com
u/Vivid-Car579 — 2 months ago
▲ 17 r/ScrapMetal+1 crossposts

Should I just scrap as is

Got in a dumpster near my house. Should I strip is or just scrap it all as is. Mostly super thin copper wires inside the insulation. Also if i do scrap it should i sort it or just turn it in like this. If i do trunk it in like this what type would it be considered?

u/Then_Marionberry_259 — 3 months ago

2024 4000 mile service advice

Have a honda ruckus used mainly to get around horse farm on a daily basis. Has a little over 4000 mile on it now. Have done oil changes every 600 miles but that is it. It seems a little sluggish from start. Wanted to get some advice on what I should do to keep it going good and long. I ordered a belt and about to do another oil change. Anything else I should get to replace since its at 4k miles without anything other then oil changes. Runs completely fine other then a little sluggish from a start, once it gets going easily 30 even on grassy land.

reddit.com
u/Vivid-Car579 — 3 months ago

Does this seem right?

Got an oil change and they said engine and trans have leaks. Don't know about cars but I dont see a leak.

2015 dodge grand caravan se

u/Vivid-Car579 — 3 months ago