u/bruh-iunno

Hi guys, I'm looking to find a battery for a small bluetooth phone keyboard I have, where my goal is to replace the original for a smaller one to fit in a tighter space to make the keyboard smaller. (original is 2300mah, looking at say ~500mah)

This would be pretty straightforward normally, however the keyboard uses a high voltage LiPo (3.87v nominal, 4.4v charged).

I was just wondering what options I have? I was thinking about using a regular 1s LiHV lipo usually used in small drones, but the original battery has three pins, one being a thermistor/temperature sensor, so I'm guessing the original battery has a BMS while one of these drone batteries would not. I am aiming to just hook up the battery to the original terminals, and use the existing charging circuitry the keyboard has. I suppose I could solder the original battery's BMS to the two terminals of the 1s lipo instead?

Any advice or input would be appreciated, thanks

Hi all,

So in some markets like mine, the key cannot open/close the windows. I was just wondering if there's any way to retrofit that functionality? Our market did not get the keyless go card thing, just a regular key (UK). I know the ND has the MX5Things module, but I don't think there's anything like that for NC.

Thanks!

Hi, weird question

I have a simple BT connected state which turns on my hotspot when the phone is connected to my car's bluetooth for my headunit to get internet access, then turns off the hotspot as an exit task.

The bluetooth connection occasionally dips just for a second or so every now and again however, so the exit task fires and then the BT connected state refires, so it knocks out the internet connection on my headunit for a solid 30 seconds as it takes a while to reconnect.

I was just wondering how I'd go about adding a sort of delay, eg "wait 5 seconds then check if the bluetooth is still disconnected, and only then turn off the hotspot" or something to that effect.

• The menu/wiki for the "If" option there doesn't seem to be an option to check a particular bluetooth device is connected like in the state menu
• Would just adding a wait at the start of the exit task work? Do exit tasks get aborted halfway through (in this case during the wait hopefully) if the state is made true again?

Thanks