u/kobevercetti

TLDR: windshield wipers locked on high speed and washer fluid also fails to spray. Pulling the wiper relay fuse stops them, but putting it back makes them run continuously.

Sup guys, the other day, I flashed my high beams a few times to let someone into my lane. Right after that, my wiper blades turned on at high speed and wouldn't turn off. To stop them, I had to pull over and pull the wiper relay fuse from the front hood fuse box.

I’ve noticed so far:

If I put the fuse back in, the wipers immediately start running

Changing the stalk switch speed settings does nothing.

My turn signals still work normally.

When I push the stalk button in, the windshield washer fluid does not spray.

Has anyone else experienced this and is there any fix?

Q;DR: windshield wipers locked on high speed and washer fluid also fails to spray. Pulling the wiper relay fuse stops them, but putting it back makes them run continuously.

Sup guys, the other day, I flashed my high beams a few times to let someone into my lane. Right after that, my wiper blades turned on at high speed and wouldn't turn off. To stop them, I had to pull over and pull the wiper relay fuse from the front hood fuse box.

I’ve noticed so far:

If I put the fuse back in, the wipers immediately start running

Changing the stalk switch speed settings does nothing.

My turn signals still work normally.

When I push the stalk button in, the windshield washer fluid does not spray.

Has anyone else experienced this and is there any fix?

Hi guys, so yesterday I did a one step polish on my car, and then added a layer of Carpro cquartz uk 3.0 right after. Unfortunately the sun set by the time I was finished with the first layer at around 9:30pm, so I wasn’t able to add the second coat. I worked outside no garage.

I am aware on the website that it says if you miss the 45-60 minute window, you can wait until the following day to add the second coat. Does that mean I can add it right now? (It’s been 14ish hours) or do I have to wait 24 hours?

Also, since it’s bee sitting outside overnight under a overhead cover, there’s going to be some debris on the vehicle. Do I wipe off with a clean microfiber towel?

Thanks

Hi guys, so yesterday I did a one step polish on my car, and then added a layer of Carpro cquartz uk 3.0 right after. Unfortunately the sun set by the time I was finished with the first layer at around 9:30pm, so I wasn’t able to add the second coat. I worked outside no garage.

I am aware on the website that it says if you miss the 45-60 minute window, you can wait until the following day to add the second coat. Does that mean I can add it right now? (It’s been 14ish hours) or do I have to wait 24 hours?

Also, since it’s bee sitting outside overnight, there’s going to be some debris on the vehicle. Do I wipe off with a clean microfiber towel? Do I also use CarPro eraser before adding the second coat?

Thank you!

Hi guys, I've been using Shear Revival Northern Lights for the past 2 years and its been great. But as of recently i noticed that during hotter weather, it weakens A LOT and doenst hold after a few hours. I realized theres probably a better product for me out there.

I'm looking for something similar, that has low shine, medium-high hold, that can last through hot/humid weather and water resistant? (if i could go in the pool for a bit and come out and it hasnt washed out that would be amazing) But would like for it to wash out mostly with conditioner

I have straight, fine, short-ish lengthed hair. Any reccomendations??? thank you