u/45skyshy — reddlx

Modxo Lite issues

ModXo lite isn’t booting into PrometheOS when I turn on my Xbox. I have to hold down the eject button and then it boots. I am stuck.

So far I have flashed my Xbox 1.0 back to stock bios and removed the TSOP bridge points.

I have reflowed the LPC and touched up all 3 solder points for the D0 plug.

I formatted my hard drive and reinstalled XMB4GAMERS dashboard

I flashed Modxo with PrometheOS & Modxo .UF2 files again. Then I flashed Cerbios 3.00 .bin

I pretty much reset my Xbox and started over and I’m still encountering the same issues as I did before. Should I ground D0 on the board instead of using the D0 ground on the provided harness? I kind of want to TSOP flash Cerbios to my Xbox and remove the ModXo because it’s giving me more headaches.

reddit.com

u/45skyshy — 3 days ago

▲ 42 r/PS3

PS3 is Back!!

I saw another post on here about someone inquiring about sending their console to get repaired by Fredericksburg Console Mods.

I sent FCM a message on Facebook and it was odd. I didn’t receive any response on Reddit, but FCM did respond on facebook. After a bunch of back & forth I mailed my console off. Be prepared to wait. From the time I mailed my console to today when it was delivered took a month. Your experience may vary, but I was quoted a 1 week turn around originally. I’m happy though, I wasn’t in a rush to get it back.

It’s playing fine without issues, but I’ll provide an update in the future if any problems arise.

u/45skyshy — 7 days ago

▲ 6 r/XboxModding

Modxo Lite help

I installed my Modxo lite and the lights on the board power up, but my Xbox screen stays black. I can boot into PrometheOS by holding down power & eject on my Xbox. I flashed the Modxo with Cerbios 3.1.0 beta and added the Cerbios folder to my E drive. I can load into XMB4GAMERS by selecting the Cerbios BIOS from PrometheOS, but if I turn off my console and power it on again I get the black screen.

My console was TSOP flashed prior to installing the Modxo and I thought that might be interfering, so I removed the R7R4 & R7D3 bridge points on my V1.0 Xbox board. I am still getting the same black screen when I try to power on the console normally.

u/45skyshy — 7 days ago

▲ 8 r/originalxbox

My Xbox was working fine yesterday and then today it made a loud pop while it was powered off. The culprit looks like a popped resistor and I’m wondering if it’s worth it to recap and replace the resistor or to just buy a modern PSU and replace this one.

Let me know your thoughts!

u/45skyshy — 18 days ago