u/ArrowLeafTurn1

I’m assuming the steps are:
- use tractor to take off grass
- Do I need to put down fabric barrier or is it unnecessary?
- where my shadow is, it’s about 12” lower than the driveway. Can I just add that much crusher run?
- add crusher run
- spread with bucket and back blade (I don’t have a box blade)
- use plate compactor once spread

Anything else?

I want to make a free floating wall shelf. I’m going to use 2x2s for the bones (in the picture, the dark pieces. Sorry for the bad pic), screw the the bones 2x2s into the studs, and then make a “shell” (in the picture the stained piece of wood). The shell will just fit over the bones.

Its kiln dried

My question is: Do I need to use nails or screws for attaching the shell to each other? (Horizontal top and bottom pieces and attaching them to the vertical sides) or can I just glue and clamp?

I’m either going to cut the shell pieces all at 45 to attach to either, or at 90. Open to recommendations on that one.

Right now I pull out the filter, wipe it off, and use a stick to get anything at the bottom, below the filter. Whats recommended to be more efficient and thorough?

First time tractor owner

Central/northern virginia. A wet area

I sharpened the chain - but it still cut dull. I don’t see any visible damage to the chain. Before I sharpened, I think I hit some dirt in the bark of a tree so maybe I just need to sharpen it more/longer?

Husqvarna 550xp - I use one of the sharpening tools as seen in the image

How do you know when the chain needs to be changed if there’s no visible damage? (Broken teeth, etc)

I have a separate network
For guests and they are always required to login after putting in the password. Where can I change the settings or what toggle can remove this requirement?

I have lots of them - hopefully you can see leaves and bark well enough

Local dealer said I need a special tool to take this off, but he didn’t know the name of the tool. Any guidance? It’s in a groove

In addition to the nubble lighthouse, what should we do/see? I have a kids 14 and under but they are pretty adventurous.

I’ll be there two days/nights, starting this Thursday

1st time cat owner. White is male. Black female. Neither spayed/neutered

Edit to add: these cats have been around each other for a few weeks and we find them often playing, sleeping beside each other. Since most of the comments say that they are about to fight, is there a reason they’d act that way all of the sudden? (They ended up just going there own way after a minute)

It appears that the only ways to access are cutting the cover altogether or one of the pipes.

Was this installer correctly? Is there a better way?

I want to measure space btw feeders and table to compare with the cutter and table so that they are set correctly compared to one another - are there calipers to do this? Or am I able to with this kind and I’m just a bit slow.

Index finder shows gravel still good. Middle finger is where it’s washed out. Whats the best way to maintain and recover this part by middle finger so it doesn’t just get more covered in mud?

What makes the board pop up when going through the planer on both the way in and as it exits?

And how do I fix it?