u/KillaC98

This stootz puts caf-fuckin-cheese on pizza. She should have known better that to plug her mulukhiyah food on his show

Uncle Joey on TSA

This place is beat. There are cars in the driveway but there's no way anybody lives here, it's quite neglected. Gotta be just neighbors storing cars there or something. Every house in that neighborhood is $1m+ and pristine, and then there's Roy's. I know I wouldn't live there. I can't imagine anybody would.

Heard these have some shit in them that'll cause lasting tremors.

I recently got rear ended & took my car to a body shop. They had to replace rear bumper, hitch, crash bar, etc & they had to blend the new paint into the quarter panels. I believe they then buffed/polished the entire vehicle to make paint all match, old with new. This is how my hood looks after getting my car back. I picked it up on a rainy day and this wasn't obvious to me, I also was paying more attention to the rear when inspecting it. What the heck happened? Clear coat severely damaged in 4 spots with the worst being right at the top center of the hood. What do I do? What happened? Burn through?

I had been looking for real M for ages, so when I saw the post that bro dropped Plur, a similar compound, I bought a few packs. I'm dying to try an entry level dose but I'm quite nervous about the hangover. I really don’t have a few days to lay around feeling like shit afterward. From much of what I've read, the hangover really starts 3 days later? And last a couple days? I've also read of people feeling nothing but an afterglow days later. What should I truly expect? And is there anyway to try this & mitigate after effects? How bad is it really???

Maybe this stuff just isn't for me. Let me know please TIA

The text says "A100k". I need to replace this potentiometer because I've soldered this wire back on twice and do not want to do it again. When I replace it I'm going to change my wiring harness to reduce stress on these soldered points. My question is… Could I replace this A100k with a B100k? I realize "A" is logarithmic & "B" is linear. This is used to adjust the weight of the steering in my track car. A Linear one almost seems better. What do y'all think? TIA

There is no text on it at all & only 2 of the terminals were used. It is part of an aftermarket electronic power steering kit for a car.

Very wavy floor pan. The washers kind of just "hover" over much of the surface area & do not sit flat or make great contact at all. And my question was... is skipping the large top washers ok? I do have Schroth backing plates underneath the floor. In my mind, the risk is the anchors tearing up thru the floor in the event of an accident, not pushing thru the bottom. This seems fine to me but I'm running it by yall for peace of mind. They are just test fitted for these pictures & not tightened.

Im not too sure where to ask this but figured here would be ok. Anyways, I'm not using the large washers due to my floor being so wavy, they won't sit that well on top. Is this ok? I am using large backing plates under the car that these eyebolts go into which won't allow them to rip thru the floor in the event of an accident. Is skipping these large washers on top ok?