
Can’t believe I waited so long to buy this game
Not typically a Soulslike player, I suck at them. I downloaded on Thursday, already 13 hours in. Absolutely incredible.

Not typically a Soulslike player, I suck at them. I downloaded on Thursday, already 13 hours in. Absolutely incredible.
My warranty has expired, so that is not an option. No matter how many docks and software settings I try, I can no longer output video from the device to a monitor or a TV. What is my best option? Try to have Asus repair it or maybe go to a third-party repair source?
First of all, I want to say that I very much enjoy reading the posts on this subreddit due to the overwhelming supportive feedback that the community brings. It is such a breath of fresh air from the majority of Internet forms.
When I first started perusing this subreddit within the last year, I told myself that I still had time but now I am not so sure. For some context, I am 6 feet tall so there are not many people looking down on my head. This haircut is also about two weeks old and is usually how I have it styled. It has almost always naturally part this way, and I usually don’t mess with it too much, I just follow the flow of whatever my cowlick wants to do.
So question one is, do I still have time and if I do have time, does anyone have styling suggestions?
Thank you all in advance, I really appreciate your time and energy.
The 3D printed airboat saga continues. After I got the stock electronics wet, I purchased a Radiolink RC6GS V3 that came with a receiver as well. I attached them to my stock ESC and brushless motor and once the self test was completed, the motor went to 100% throttle immediately. The only way I can prevent this from happening is by (oddly enough) pulling the throttle trigger of the transmitter all the way back. If I let ago again, the motor goes to 100% throttle. I've searched online for answers, I made sure the cruise control wasn't enabled, I reversed the channel, etc. I also purchased a new Spektrum SPMXAE1030 ESC with the same results.
If I plug everything back into my old receiver though (which works sporadically), the motor/throttle acts completely normally.
Any thoughts and guidance are appreciated, thank you all!
Some of you may have seen my recent post about my 3D printed airboat. Long story short, It got wet inside and I think the receiver I installed from my Aeroscout (Spektrum AR636) is toast. I was looking to get a direct replacement, but didn’t want to drop $70 for a new one, especially when I need only 2 channels instead of six. Looking for suggestions on just another drop in replacement receiver or another receiver/transmitter combo without breaking the bank. Water resistant would be preferred, but again, I’m trying to work within a budget. Thank you all!
Years ago I crashed my Aeroscout 1.1 into the ground hard, a total loss on the air frame. Last week I salvaged the electronics out of it and printed an airboat. Still needs some adjustment, but this thing cooks! Link to the boat model below, all credit to Armengol13 on MakerWorld.
https://makerworld.com/en/models/876080-radio-control-racing-boat-aerotrooper#profileId-829043
The Phoenix got new Jconcepts Tusk tires, Injora blue silicone tire inserts, 30w shock oil and I 3-D printed a clipless body system. She’s ready for more adventures!
So I just tossed this body on one of my rigs and it came with 2 different sized headlight covers. The larger one fits perfectly, the smaller of the two is too small. I ordered a replacement body kit from Amazon and it only had the two smaller headlight covers. Has anyone else experienced this? Should I just get in touch with Injora customer service to get a replacement or roll the dice again on Amazon?