u/MullenPlays

I finally started the process of customizing my jacket! Waiting for the weekend to add some more paints to give some more accents to it. Also going thrifting for a show vest to start on soon! Already have some patches in, just need to decide on which they will go on

Finally started my jacket, wasn't a fan of the full brown look, but as I was dying it decided to keep some brown accents to liven it up a bit!

Hello everyone! I have struggling with getting any prints to be successful yet, I have tried anywhere from 30-60 sec on my base exposed, as well as anywhere from 1.9-8 sec for layer exposure. I have been attempting test prints for almost half of my bottle of resin. It is the yellow washable resin I received with my printer. I have a Saturn S as well. I have tried multiple test print files and either end up with prints not fully printing to not sticking to the build plate. I have done a full exposure test on the vat to get the layer out as well as cleaned my build plate to ensure it sticks to no avail. Any tips would be very helpful!

Hi everyone, I recently purchased an Elegoo Saturn S. I am trying to narrow down my settings, I have only printed 3 test prints so far, specific model is tabletop foundry's cones of calibration. The third model was the worst of them all with almost nothing actually printing. I am using a yellow water washable resin that I received with the printer. The resin b9ttoe suggests using 60s bottom and 8s for each layer. This is my first interaction with resin printing, but I have years of experience with FDM printing. Any help would be much appreciated!

After the performance of my kharn carrier in my last match, it has finally earned its paint job, with all the blood and skulls we can carry

I found some horus heresy terminator models on ebay. We are now working on the paint a bit to give them a little more love! Top is the first one I have touched up, while the other is what arrived. Next will be the basing scheme to help them blend in to my battle force!