
Am understanding this correct?
Is this kit so that once it is installed it will give me clicky triggers and if I want to switch back to the default analog trigger I do it with the little lever? 🤔

Is this kit so that once it is installed it will give me clicky triggers and if I want to switch back to the default analog trigger I do it with the little lever? 🤔
I have a 8bitdo Ultimate 2 Wireless that is recognized in the game without any problems but then I have no gyro. To use gyro I have to use D-input and the it isn't recognized by the game. Tried Steam Input and no luck there either.
Any ideas?
Will a DSi run with charger plugged in even tough the battery is toast?
A friend handed me her DSi and asked me if I can get it going again. I am thinking of softmodding it an putting a bunch of games on the sd-card. New to DS and don't know if there are any restrictions when it comes to the size of the sd-card. Anyone?
My "fancy" diver.
Tja!
Hur lång tid tog det från att du skrev upp dej på listan tills du faktiskt fick den levererad?
Neo Brothers in UK built this some years ago. Still my favorite resto-mod!
Ägde aldrig nån PS1 så det här blev kännt för mej ganska nyligen.
How long after signing the reserve list have you gotten your Steam Controller?
Got one cheap and I've noticed that the rubber often degrades over time for other people so I put a skin over it after only two days use. Just curious if this will make it last longer.
Anyone tried it?
This is a close-up of 8bitdo-controllers (Pro2) mainboard and these carbon-pads connect the shoulder buttons and the trigger which is on a separate module. I want to mod the trigger and a use a mouse-switch for the trigger instead of the membrane-button. Looking for a good place to solder the wires for the switch. If I gently scrape away the carbon is there copper underneath that I can solder on to?