What could be causing these ripples? I’m printing basic Bambu PLA on a X2D with pressure advance calibrated, first-layer flow at 1.05, and Z-offset at 0. Still, some areas look under-extruded and others have too much filament piled up
Shot with a manual 50mm and an old DSLR
Been stuck on this for days, attaching my settings below.
Flow looks uneven across the print, some spots seem underextruded, others slightly overextruded. Every right angle leaves a nasty intermediate line right at the turn, and any hole or design change makes the lines around it look shifted, plus the holes themselves come out rough instead of clean.
Already ran every typical calibration (flow rate, flow dynamics/pressure advance, vibration compensation), more than once. Dried the filament, checked belts, cleaned the nozzle, no clogs. Still the same pattern.
Anyone else dealt with this on the X2D? Trying to figure out if it's a setting I'm missing or something mechanical with the extruder/toolhead.
Hi everyone!
I’m deciding between the Behringer Pro-800 and Roland S-1 for studio use.
Mainly for fat/thick sounds: Reese basses, lush pads, and powerful leads.
Has anyone used both hands-on?
Hey again,
Some time ago I posted asking why you wouldn't buy from glorytheshop.com.
You gave me honest feedback. I appreciated it.
Since then I've been heads-down building. I reworked the design, improved navigation and tightened the product curation. The store is in a different place now.
To my eyes it's improved, but is there anything I might be missing?
As potential customers, is there anything that puts you off or makes you look for alternatives instead?
Found these dark botryoidal rocks in an old mining area (Galicia, NW Spain)