My main box is an ONN Pro V1, although I do have a third generation fire cube in our upstairs bedroom. The Tablo is connected to the downstairs ONN Pro and works fine. I’ve installed the app on the fire cube, but it does not find the Tablo. Is there something I’m doing wrong, or can it only be connected to one box at a time?
Question, about my OTA antenna connection. I have an outdoor antenna with a clear shot to the southeast, which is what I need. However, all of my equipment is on the lower floor of the house on the complete opposite side. Near both the antenna and the equipment, including my TV are cable jacks. If I connect the antenna to the upstairs cable jack, and then run a coax cable from the downstairs connection to my Tablo, will that pick up the signal from the antenna? The reason I am asking is that I have my Tablo in the upper bedroom directly connected to the antenna, and I would like it to move it down to the rest of the equipment and plug it in directly to the router.
Question, about my OTA antenna connection. I have an outdoor antenna with a clear shot to the southeast, which is what I need. However, all of my equipment is on the lower floor of the house on the complete opposite side. Near both the antenna and the equipment, including my TV are cable jacks. If I connect the antenna to the upstairs cable jack, and then run a coax cable from the downstairs connection near the TV into the TV, will that pick up the signal from the antenna?
Posting this b/c the post was closed because b/cI had already reported it, but I mentioned that I had done that when I posted it.😉 in any case, I am running 2.3.1, and it does happen occasionally. No big deal at all, just making the devs aware.
I have an issue, and could use some help. First, a little background with regards to my set up, I am a fire cube user for many years, and heavily invested in the home theater platform. However, I transitioned to the pro box sold by Walmart as my primary box, and I use the HDMI input on the fire cube so that I can use the box but preserve the home theater functionality of the cube. This works fine. The issue is with the Walmart box remote. It operates everything perfectly, and as far as the volume is concerned, it had also worked perfectly, it would increase and decrease the volume on the cube as normal. However, suddenly the volume control does not work. All the other controls work fine I just can’t figure out why the volume control suddenly isn’t working because it was working before. I changed no settings. See attached, this is how it’s set up in the android settings. I have CEC enabled on the TV, cube and box. Interestingly, if I change the setting to Samsung, which is my TV, the remote operates the TV volume fine. It just won’t do it on the cube. Any ideas? But the way, didn’t state the name of the box b/c of group rules.
Devs, see attached , an issue I reported before. When escaping out from a full screen channel, the channel list is blank. If I navigate to another category and then back to my favs, it comes back. I’ve not been able to find a consistent cause; seems sporadic.