Can anyone recommend a detail-oriented trim carpenter for crown moulding installation?
I need crown mould installed in one room and am hoping to find someone who may have availability fairly soon. I am looking for someone who does careful finish work, especially with corners and clean seams.
Thanks very much for any recommendations.
I've been helping with trail maintenance for the last few months and diesel for the track loader is getting to be a pain. Since it is heavy equipment, I can legally use off road diesel in it.
Anyone know a station nearby (preferably on west side or between Athens and Greensboro GA) that sells red diesel? I've not bothered till now since prices weren't that horrible.. but $5/gallon is killing me haha
Legit, if you need any grading work done hop in my dms and I'll send you my side hustle site.. been operating equipment for almost 20 years
I'm on west side.. just one 2x6 board about 4' long, and it needs to be planed down about 1/2"
If you have one, are close to town and don't mind helping out please let me know!
I ran into one of the site managers for the construction company working on the big project out by the mall.
He said all four new ramps will open at roughly the same time, rather than staggering them.
After the entrance and exit ramps open, they will turn to start work on the Atlanta highway overpass.
Get ready for the bad news:
Unfortunately for anyone who regularly travels in the area, they are planning to shut down one side of the bridge and route four lanes of traffic into two lanes.
When they're finished with one side of the bridge, rinse and repeat the other. Traffic is going to be horrible probably for a good 8 to 12 months if not longer.
There's not an easy workaround for traveling across the bridge. Prepare for pain.
When finished, the bridge will be 4 ft taller than the current overpass.