u/r2doesinc

The CFS is not detected, and I just get system error, restart codes, plus the motor init failed whenever trying to do anything.

---

Someone said they experience the same thing due to some mods to the cfg that were overwritten.

I have the dxc2 extruder, so there's some very minor config changes. Maybe that's it 🤷‍♂️

---

It was the cfg, but not the dxc2 - though i did need to reapply the changes for it. The issue was the missing screw tilt macro.

I have an FDM printer in my workshop room,l with some HEPA filters and such. It's on the other side of the house for the living areas and works for FDM.

I'm looking to go resin, and wondering if my garage is sufficiently safe. I could print with the garage door up if necessary, and there's also a window I could setup with a vent if needed. The garage is attached through a small kitchen door, on the far side of the 2 car garage I would be setup in.

The options are

1. Print in garage, it's fine

2. Print in garage, but keep the door up

3. Print in garage, duct it to vent outside, don't risk it

Not sure what happened, but every swap started to fail, and I realized the cutter is now completely missing from my extruder. No clue where it went unfortunately, and now I'm stuck 90% through an 18+ hour print doing manual swaps.

I don't see a way to buy just replacement cutters online.