It is the EEG headset he uses in his “Using Mind Control to Drive a Car” video. I have been trying to n to find it online for SO long and I can’t find anything similar. Literally either this or any other EEG headset you can buy where you can code it to do what you want.
I found this video and it seems simple enough to make. I am a beginner though, so I wanted to make sure this would work before I actually bought everything. Thank you!
I am currently creating a light show using an arduino mega and 8 channel relay. I connected In1-8 to the arduino mega, and a 9 volt battery to vcc and ground. When I put the 9V battery to the VCC and GND then it lights up the arduino mega and the 8 channel relay. I also have two wires going from the GND and VCC on the 8 channel relay to another GND and 5V on the board. How do I connect a 12V to the relay so it can power the lights
I am currently creating a light show using an arduino mega and 8 channel relay. I connected In1-8 to the arduino mega, and a 9 volt battery to vcc and ground. When I put the 9V battery to the VCC and GND then it lights up the arduino mega and the 8 channel relay. I also have two wires going from the GND and VCC on the 8 channel relay to another GND and 5V on the board. How do I connect a 12V to the relay so it can power the lights.
I’m making an automatic firework launcher and I almost have it complete. I need help on if I should use an electric match or rocket igniter. And where do I even find those because I have looked everywhere and could not find them. And finally, how do I connect it to the 8 channel relay? I already have power in the relays, I just need to attach a rocket igniter/electric match to each relay. I have a common ground so do I get all the negatives together and put that in the common ground and then put the positives in one of the holes of the relay or what?
I am making a firework launcher for the fourth of july. I’ll try to explain it but i’ll link the tutorial that I was originally going off of but I had to guess where lots of the wires go because there was not a very good wiring diagram.
https://projecthub.arduino.cc/codemakesitgo/easy-firework-firing-system-c2f74b
So as far as I understand, the power goes from the 12V battery to the buck converter which makes it into 5V. the power then goes to the blue thingy on the mega sensor shield. There is also the remote switch, which I have been able to make click when I press the on button on the remote. The yellow wire goes to VIN+ on the FET switch, the white wire goes to the trig/ pwm part on the FET switch. The red wire goes to the 5V and the black wire goes to the GND each on the mega sensor shield. There is also a wire going from trig/pwm part of the FET switch to A0 on the Mega Sensor Shield. There are also wires going from the numbers on the mega sensors shield to the 8channel relays from IN1-IN8. and just as a side note: The FET switch, tbh I have no idea what it does but the guy from the tutorial has it and the power is still getting through without burning the arduino so 🤷♀️.
Those are all the wires. I have no idea how to get the power from the arduino mega to the 8 channel relays. I have added code to make an LED blink it did not work. As you can see in the photos there are 4 of the 8 channel relays and that is my end goal. But for now I want to just get one working. I truly am lost from here and it’s not like i’m an electrical engineer, in fact i’m literally a hs freshman. This is truly a last resort and does anyone have advice.