u/yoko911

big chip and it looks like it took the hardened steel, should i do uradashi before trying to remove the chip?

seems to be a rabbet plane, however the blade seems to be wider than the body, should i grind down the blade? also what else is needed to tune it? do i need to flatten the sole or 2 point contact such as a regular plane?

won some planes in an auction, trying to make 1 out of many , found this one, it’s obviously missing the fence, but i can’t think of what that leading tip/blade is doing

saw some videos, popped the trim and was expecting screws but only see goops of silicon, i removed some of it and don’t see any screws

i’ve seen some videos of people instead of pouring concrete footing into the soil they use buckets filled with cement, does that mean I could use pier blocks for small pergola?

Is there a way to buy just the charging case? I don't need wifi booster, hoping to pay less just for the case/charger, thermometer worked until it ran out of battery

would like to add a usb port in one of these blanks, my land cruiser has no flat blanks but the ones that are for coins, anyone knows the size of blanks i can get? i tried getting one from amazon around 40mm long and it was a little short,

removed the screws from center console but i can’t find a way to remove it, thought i would go thru the shi later but cannot unplug the button wires, any tips?

found it on my dad old garage, I can’t seem to read the sticker, i would like the brand to see if I can get the missing cutting depth screw 🤔

floating countertop how to achieve that channel? thought of having the normal cabinet structure and then overlay the venered plywood but that seems too much waste of material

new to me kzj78, previous owner raised the suspension , but it needs new shocks as these have lost all the juice, i would prefer a stock height so looked for the original EMS shocks, found them pretty expensive (300 usd each one) so are they worth it? if not what would be a good replacement to keep it stockish? probably will just cut the springs to size

there are some weird glares and looks like water stains on my project :(, this is 8 hours after applying 2nd coat of Rubio monocoat, i think is some glue i used with sawdust to film some holes, I used a damp towel to remove the excess glue, guess it got pushed to the fibers.

so how would you recommend i remove this finish and the glue or whatever stains these are?

this is finished like this:
Sanding: 80, 100, 120, 180 (don’t have 150 but could get it), vacuuming between each grit
water popped,
hand sanding with 180 with grain to remove the popped fibers,
then mineral oil to clean,
once dried applied Rubio with a spatula, used a white scotch pad in orbital sander, then blue towels to remove excess , then after 15 minutes used a maroon pad to sand the finish, vacuum and mineral oil to clean, second rubio application as above minus the maroon pad

Land cruiser prado KZJ78, both front wheels has this unplugged connector 🤔🤔, is it for the HUB or suspension?, there seems to be a suspension button inside but it does not light up or do anything

Some forums claim it's the RM183E but looking at the cover it doesn't contain the KZJ7, this is a 3.0 Turbo diesel, If anyone can share some knowledge? the LC is in the garage, want to flush every fluid and need some info on it