u/Fuzzy_Button6648

I have the 2018 silver/ black oem wheels size 18 to trade or can buy outright.

Thanks

Anyone ever re pin the low beam or high beam
Connector? Having a hard time finding pins that will connect to oem connector

Noticed there is mold inside of AC unit. How hard is it to disassemble and clean back in there. Probably worse than I can tell but AC unit is only 3 years and cost 450$

Hi all- anyone need these? Was running fine in car. Oem. Have all 6 of them

Hi all wondering what some of you guys upgraded to? Thinking about getting this, oem is same price

Hi guys will be cleaning and changing bushings this weekend. Any specific ports I need to seal before I start cleaning and power washing outside?

Thanks!

Changed it from my old post. Where I had 90 degree elbows. I think this is much better

Does anyone know where to get smaller clutch tool for pilot bearing. 1993 e30 convertible
Ordered this one on eBay and it was incorrect size

Hi guys,

What’s the best way to simplify this? Should I add a 45° elbow from the drain with a p trap connector, then connect the P-trap up to the sink?

Tried to change drain pump. Recalibrated and it still making this noise.. is it the control board wtw4800xq4 model

Transmission is undergoing overhaul and realized the tab was broken on the right side. I now garagistic offered these but looks like they’re sold out now.. need to get it welded back on!

I have poly engine bushings and poly condor transmission bushings.

Anyone need them- will take 35 shipped for both engine and trans

Has anyone done this modification? Where do you re route the vacuum line from the valve cover gasket?

I saw it would connect to intake but having a hard time figuring that out

Paint store recommended zero rust. I have seen some stuff on 2k primer? What is good to use, engine bay and located by exhaust

Previous owner used jb weld. I anticipate on getting a new throttle body. This looks sloppy and I’m rebuilding the engine. Anyone have any experience with this?

Have the engine out of the e30 93 vert right now for full rebuild.

Plan on sanding it down, spraying with 2k primer and then painting. Looks like the rust is inside also. Anyone have any experience with this particular area and what to do to stop it?